Restart and Reset to default values
While restarting the DO-1 device, the LEDs, i.e. indicator lights, serve as visual indicators for the various phases and times. Holding the reset button allows you to initiate the desired change.
Restart
Press and hold the reset button
All LEDs go out except for the power LED, which remains on continuously
Once the BUS LED lights up, release the reset button
The device then restarts
Reset Values (Default Status)
Press and hold the reset button
All LEDs go out except for the power LED, which remains on continuously
Once the BUS LED and ETH LED lights up, release the reset button
This resets all values, and a new configuration is created
ℹ️
If uncertainties arise, you can safely neutralize the situation by holding the reset button until all LEDs turn off. The LEDs will turn off after 15 seconds, and no changes will be made to the system.